Preventive Maintenance
With regular maintenance you will prevent small problems from becoming big problems and ensure optimal performance of your comfort system. We also offer annual service agreements, which can reduce the cost of a Performance Tune-Up.
Regular maintenance will:
- Provide longer lasting equipment
- Reduce utility bills
- Reduce repairs
- Provide a more comfortable indoor environment
- Protect your investment
What we do during a Performance Tune-Up:
Performance Furnace Tune-Up
- Perform heat exchanger inspection
- Clean and adjust all safety devices
- Inspect pilot and/or flame sensor
- Clean and inspect burners
- Inspect motors, and if necessary, lubricate
- Clean and replace standard filter if necessary
- Check for carbon monoxide leaks
- Test for natural gas leaks around furnace
- Check blower compartment
- Check furnace for proper cycling
- Measure temperature variation on supply/return
- Check and adjust tstat if necessary
- Check, and if needed, tighten all electrical connections
- Inspect condensate line
- Inspect condensate pump
- Check duct work
- Inspect fanbelt tension
- Check thermocouple
- Test ignition system for proper operation
- Measure blower motor ampage and voltage
- Test safety and control circuits for proper operation
- Customer consultation on condition of equipment
Performance Air Conditioner Tune-Up
- Check operating temperatures (Evaporator temp drop)
- Check voltage of outdoor compressor
- Check and adjust supply and return vents if required
- Inspect motors and if necessary lubricate moving parts
- Clean or replace standard air filter
- Check low voltage wiring and contactor
- Inspect condensate line
- Inspect condensate pump
- Check, and if needed, tighten all electrical connections
- Check for visual refrigerant leaks
- Check, and if necessary, adjust thermostat calibration
- Test humidistat operation if applicable
- Check ductwork
- Test safety and control circuits for proper operation
- Test float switch if applicable
- Inspect electronic air cleaners if applicable
- Check temperature differential
- Check fan motor amperage draw
- Inspect service valves
- Check condenser coil and advise
- Clean and adjust blower components
- Customer consultation on condition of equipment